Code Search

Please fill the "Code Box" to find engine fault code.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

Other Ford Cars:

Ford Ikon C1304 Engine Trouble Code

Theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

Ford Ikon C1304 Code Meaning :

C	1	3	0	4
OBD-II Diagnostic Chassis (C) Trouble Code For Engine	Fuel And Air Metering	Throttle/Pedal Position Sensor/Switch A Circuit Intermittent	Cold Start Injector 1 Malfunction	Timing Reference High Resolution Signal A Too Many Pulses

When you check Ford Ikon car engine light came on code C1304 the reason should be . However manufacturer may have a different definition for the C1304 OBD-II Diagnostic Chassis (C) Trouble Code. So you should chech it on our car models.

C1304 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for C1304 code is occuring now you should check C1304 repair processes.
Now don't ask yourself; What should you do with C1304 code ?
The solution is here :

Ford Ikon C1304 Possible Solution :

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

C1304 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1304 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Reason For C1304 Code

The reason of C1304 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

Parts or components should not be replaced with reference to only a C1304 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

	Example: 0120