Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

C1304 Engine Trouble Code

Meaning of C1304 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C1304 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for C1304 code is occuring now you should check C1304 repair processes.
Now don't ask yourself; What should you do with C1304 code ?
The solution is here :

C1304 Possible Solution:

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

C1304 Code Meaning :

C	1	3	0	4
OBD-II Diagnostic Chassis (C) Trouble Code For Engine	Fuel And Air Metering	Throttle/Pedal Position Sensor/Switch A Circuit Intermittent	Cold Start Injector 1 Malfunction	Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C1304 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1304 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For C1304 Code

The reason of C1304 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

C1304 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

	Example: 0140